Architecture Paint

SOON&SOO WATER-BASED VARNISH

usage
Wood Interiors
Multi plus top coat
Oil-based lacquer, enamel old film (interior)

This product is an eco-friendly coating agent suitable for wooden accessories and interior wood finish. It is a air-drying water-based paint composed mainly of fast-drying water-based copolymer special resin and urethane resin, which is made by developing the oil-based vanish into an eco-friendly water-based varnish. It is a highly functional water-based paint that is excellent in dryness, durability, filming forming, and adhesion. Thus, there is no need to worry even if it is applied to old coating of oil-based enamels and lacquers.

specification

Paint type
Acrylic / Urethane resin
Drying time
Drying time
Category 5℃ 20℃ 30℃
Dry-hard 3~4 hours 2~3 hours 1~2 hours
Time required for re-coating (min.) 2 hours
Thinner
Tap water(dilution rate: less than 10%, volume ratio)
Coating Method
Brush, roller, spray coating
Specific gravity
Approx. 1.04
Solid volume ratio
Approx. 23 %
Theoretical Coverage
7.7 ㎡/ℓ/2times ※ The application amount may vary depending on basis materials with sever absorption.
Thickness of dried film
30㎛ (2 coats recommended)
Re-coating interval
20℃, sufficient ventilation for a minimum of 2 hours
Color
Transparent
Gloss
Glossy, semi-gloss, matte
Storage and preservation
12 months (well-ventilated dry, cold and dark location, room temperature 5℃~30℃, humidity less than 80%)

PRODUCT PROPERTIES (PHYSICAL PROPERTY DATA)

Beautiful appearance
Imparts a beautiful appearance by smoothing the timber surface.
Mildew-resistant effect
It has antibacterial, antiseptic effects.
Adhesion
Adhesion to old films of oil-based lacquer and enamel is excellent.
Environment
Obtained eco-label certification

how to use

Surface treatment
1. Smooth the rough surface of the substrate by grinding it with sandpaper #180-220 along the grain.
2. Completely clean grease or contaminants and abrasion powder on the surface of the substrate and thoroughly dry it.
3. Thoroughly dry the wet wood and completely remove the mold before coating.
Coating method
1. Varnish should be used after slowly stirring to prevent bubbles.
2. Re-coat the varnish after drying for 2 hours after the primary coating. Avoid excessively thick coating upon one coat. (Air bubbles are likely to occur)
3. If the re-coating interval is short, air bubbles may occur during drying after the entire surface coating.
Preceding and follow-up coating