Architecture Paint

SUPER ENAMEL Alkyd gloss enamel

usage
Top finishing paint for steel structures such as commercial buildings/residential buildings/public facilities

SUPER ENAMEL is a gloss enamel product based on medium oil alkyd resin. It is a paint with quick drying ability, excellent hiding power and workability that can be used easily by everyone since no sagging occurs during painting. It is also a top coat finishing paint suitable as an indoor and decorative finishing paint that has a hard coating film, excellent adhesion, color retention and water resistance, and long-lasting gloss.

specification

Paint type
Heavy oil alkyd resin / Top coat
Drying time
Drying time
Category 5℃ 20℃ 30℃
Set-to-touch 4 hours 2 hours 1 hour
Dry-hard 16 hours 8 hours 6 hours
Time required for re-coating (min.) 30 hours 16 hours 10 hours
Thinner
DR-306
Dilution ratio
Volume ratio : 10%
Specific gravity
Approx. 1.1(based on white color)
Theoretical Coverage
7~8㎡/ℓ (2times - 60㎛)
Solid volume ratio
Approx. 42~45%
Color
White, other colors
Thickness of dried film
2coats - 60㎛
Mixing ratio
One-component
Flash point
At least 30℃
Gloss
Glossy
Shelf life
12 months (Dry, cool, and dark place with good ventilation)

PRODUCT PROPERTIES (PHYSICAL PROPERTY DATA)

Workability
Flowing resistance is superior, and workability is excellent.
Film property
Light resistance, water resistance, durability, and salt water resistance are excellent.
Resistance
It is excellent in resistance to mineral oil, petroleum, grease, etc.

how to use

Surface treatment
1. New metal plate: Remove dust, oil, etc. from the surface of the substrate using xylene or another proper solvent and then remove rust or forge scale by treating at blasting Sa2. Apply after coating with a corrosive undercoat, KSM-6030 class 1 or an undercoat according to the coating specifications.
2. New wood: Completely remove dust, oil, etc. Please apply sanding treatment if necessary.
3. Repair coating: After completely removing dust, oil, etc., thoroughly remove the paint film that has poor adhesion or is damaged with a wire, apply sanding for the surface of the old film to enhance adhesion.
Coating method
1. Coating can be done by either brush, roller, or airless spray coating.
2. Airless spray coating :
- Tip diameter : 0.43 ~ 0.48 mm
- Injection pressure : 143 atm
- Injection angle : 65˚
(Airless spray data are for reference only, and it is adjusted according to the coating conditions.)
3. Coating conditions : The surface of the substrate must be clean. The surface temperature should be at least 3℃ higher than the dew point to the relative humidity should be less than 85%.
Preceding and follow-up coating
1. Preceding coating : Alkyd system primer
2. Follow-up coating : Alkyd top coat
Remarks
※ It is a KS mark product corresponding to KSM-6020 class 2 gloss grade 2.